Power Transmission

igus Adds a DeviceNet Cable to Its Torsion-Rated CFROBOT8.PLUS Robot Cable Family

The new variant is rated for torsion of up to ±360 degrees per metre and joins PROFINET, PROFIBUS, CAN bus and Ethernet versions in the same family.

Mateo AlvarezOctober 28, 20265 min read11 views

Concept illustration of a slim robot cable with a braided copper shield looping through a twisting motion beside a robot joint.

igus has expanded its CFROBOT8.PLUS robot cable family with a DeviceNet variant built for dynamic robotic applications, where cabling is twisted rather than simply flexed. The company rates the new cable for torsion of up to ±360 degrees per metre.

The CFROBOT8.PLUS family is engineered for up to 10 million torsional cycles, according to igus. A specialised shield design is credited with keeping the cable flexible through continuous robotic movement, so the conductive layers can follow an axis repeatedly without the assembly stiffening.

Reduced outer diameter

The DeviceNet cable also carries a smaller outer diameter, up to 21 percent below earlier CFROBOT8 models. igus presents that reduction as a way into tight spaces where routing room and clearance are limited.

Signal integrity is handled by a tinned-copper braided shield, which igus says helps maintain the signal under demanding conditions. Oil resistance and UV resistance are both cited, allowing use indoors and outdoors.

Intended applications

Target uses listed by igus include six-axis robots, handling systems, machine tools, linear and lead screw systems, and other equipment with continuous torsional movement.

DeviceNet is one protocol option within the family. CFROBOT8.PLUS also spans PROFINET, PROFIBUS, CAN bus and Ethernet applications up to CAT7. Bringing DeviceNet into the same range means a site running several of these industrial communication systems can draw on one cable family rather than sourcing the variant separately.

Laboratory verification

Like other chainflex products, CFROBOT8.PLUS cables are tested in igus's 5,500 square metre laboratory, where robotic motion is simulated under conditions intended to resemble real installations. The company reports that testing has demonstrated reliable electrical performance through more than 15 million cycles.

The two cycle figures describe different things. The 10 million level is the torsional duty the family is engineered to withstand; the 15 million figure refers to electrical performance observed in the company's own test setup. Both are igus statements, and the announcement does not describe independent verification of either.

For designers specifying a network cable on moving equipment, the announcement sets out three practical limits to check against a given axis: the torsion the cable can accept per metre, the number of cycles expected over service life, and the diameter the cable route can accommodate. Igus did not include pricing or availability details in the announcement.