High strain rate testing can provide material data that is more relevant to rapid impact and crash events than conventional quasi-static measurements, according to Andrea Incardona, an application engineer and product specialist at testing-machine manufacturer Instron. In the article, Incardona said simulation predictions depend on how accurately a model represents the material, especially when loading speed changes its mechanical response.
Materials can exhibit strain-rate-dependent properties, meaning their response may change as loading becomes faster. A material characterised under quasi-static conditions may therefore behave differently in a rapid impact or crash event. Incardona argues that this is not merely a theoretical concern and points to a 2025 study in the SAE International Journal of Materials and Manufacturing, “Influence of Strain Rate Effect on Mechanical and Crashworthiness Properties of CFRP Composite Structures.” According to the article, the study found that incorporating strain-rate-dependent material properties into crash simulations reduced discrepancies between simulated and experimental results for CFRP composite structures. The discrepancy in peak acceleration fell by 6.5 per cent, while mean acceleration and displacement discrepancies fell by 5.9 per cent and 6.3 per cent respectively.
Test conditions and data requirements
Incardona says high strain rate characterisation can add insight beyond conventional data. Depending on the material, specimen geometry and test method, materials can be characterised from quasi-static conditions up to strain rates approaching 1,000/s. Tests can last only 3 to 10 milliseconds, which requires data acquisition capable of capturing the material response over a very short period. If strength, stiffness, deformation mechanisms or failure behaviour change as strain rate rises, relying solely on conventional data could leave a model unable to represent rapid-event conditions accurately.
Material selection and design
The article also links dynamic characterisation to material selection. Conventional properties such as strength and stiffness remain important, but they may not show how a material will respond when loading becomes rapid. Two materials that appear comparable under conventional testing may behave differently under high strain rate conditions. Characterising their dynamic behaviour allows engineers to consider how each material deforms, absorbs energy and ultimately fails. This can matter when performance must be balanced against weight, including in automotive crash structures or aerospace components, where dynamic material behaviour can inform both material selection and component design.
From test data to development
Instron says its high strain rate testing systems support data acquisition at up to 200 kHz, while digital image correlation can provide additional information about strain development across the specimen. Analysis tools can then support data processing and theoretical modelling. The company describes dynamic characterisation as part of a development process in which material behaviour is measured, incorporated into simulation, used to compare design options and validated through physical testing.
That approach, according to Incardona, makes material testing more than a final check on an existing design. Engineers can use dynamic data earlier in development to assess whether a material is suitable, refine a component design and understand how changes may affect performance. The stated rationale is that material data is only as useful as its relevance to the conditions a component will face. High strain rate testing, the article concludes, can give engineers a more complete picture of performance from simulation through to product development.
