Automotive Accessories

Builder Flips Jeep Rear Differential Upside Down to Create a Budget Portal Axle

Zeph Gage cut the cost of portal-axle clearance to roughly a fifth of typical hardware by turning a Ford 9-inch diff over and fitting Humvee geared hubs to the rear only.

Mei-Lin ChenNovember 17, 20265 min read0 views

A workshop scene of an off-road vehicle's rear axle with an inverted differential and a geared hub at each wheel.

A four-wheeler builder has developed a low-cost portal axle for his Jeep XJ by flipping the rear differential upside down, a workaround that delivers the clearance benefits of portal hardware at a fraction of the usual price.

Portal axles are prized in hardcore off-roading because they place a stack of gears behind each driven wheel rather than letting shafts and components hang below the transmission and transfer case. That geometry lifts the axle shafts high, so very little hardware sits below the frame line. With tall tires, the setup can free up enough room for the vehicle to clear obstacles that would otherwise stop a conventional drivetrain.

The catch is cost. A typical set of portal axles from companies such as 74Weld runs about $20,000. The unit built by Zeph Gage costs roughly a fifth of that, according to the report.

How the budget build works

Gage's setup combines a Ford 9-inch axle housing, geared hubs sourced from a Humvee, and a set of Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals like the Humvee's take the rotation of the input shaft and reverse it. To correct the direction on the Ford 9-inch, Gage flipped the differential upside down so the driveline spins the right way. A Yukon Gear and Axle third member is then bolted to the diff, effectively turning low-pinion parts into a budget high-pinion unit.

The arrangement does more than add about six inches of clearance. It also preserves full shock travel, something that is difficult to achieve with portal axles, and reduces stress on the differential itself, which the report describes as effectively bulletproof as a result.

Why only the rear

Installing a portal axle on the back without upgrading the front is a common trick in the remote-control rock crawler scene. By keeping the solid axle up front, Gage avoids the packaging constraints that usually arise when fitting portal axles to a vehicle that never had them from the factory. He also does not have to limit shock travel to work around those constraints, and the ride height does not climb absurdly high. The report frames it as a best-of-both-worlds outcome.

The result is not an off-the-shelf solution. Gage did considerable custom fabrication, including homemade brackets, custom-tapped plates, and a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it offers an integrated electric emergency-brake solenoid, and partly for clearance reasons.

The finished XJ can drive over a five-gallon bucket and still have several inches of spare clearance. That means the rear end will not hang up on obstacles that the front can simply steer around. The report calls it an ingenious piece of kit that required a lot of thinking to get right.

More specifics, including how Gage matched gearing front and rear, are covered in a video from Outdoor Auto.